Once the corners had dried a bit, it looked more like this.
Mudding bathroom walls.
Learn how to add a new bathroom to a home, including tips on using mud and tape on drywall in this free ho.
If you're looking to avoid corner cracks, you'll have better success with a fully floated shower that has mesh wrapped through all corners, versus tiling over a lightweight tile backer board like cement.
Then the walls get floated with mud.
In case you didn’t know how to apply paper tape to drywall seams (i didn’t!), you put joint compound on both sides of the drywall under the tape, place dampened tape over the joint compound, and use your joint knife to smooth the tape and squeeze the plaster out the edges.
How to remove grout mortar and drywall mud from tub.
If you are doing a tile surround, the only right option is to use the 1/2 concrete backer board, which gets the mesh tape and thinset to finish the joints, not traditional drywall spackle.
Use light stroking movements to bed the tape without dislodging it from the corner.
It involves filling any joints or gaps with a thin coat of hot mud.
Use a power drill with a mud mixer attachment to create a thinner consistency of mud before applying.
14 drywall alternatives that bring life to a dull room worst what type of bathroom drywall should i use diy bathroom reno phase 4 concrete board and drywall kelley rose waller everything you need to know about textured wall paint how create walls with everything about installing tiles on.
This key step occurs after the drywall is hung and installed.
The remodel will tear out and replace all fixtures and retile the entire room up to the ceiling.
It may also keep screws in place.
Mud needs to be used on drywall before it's taped.
You will of course have to use cement board screws to attach the drywall so things could get expensive.
These are some of the main steps that involve mudding:
If you did cement board the entire bathroom then you could apply drywall on top of it and end up fairly flush with the tilework.
The last mudding drywall task is to apply a third coat to cover any remaining imperfections on the drywall.